Snap-on Motorized Loader Bedienungsanleitung PDF herunterladen (Seite 88)

6-16

2000-800-02 Motorized Loader

DIAL , BEAM OR SCREW DRIVER MODE:

( This mode is used to check or test the Dial wrenches ).

· Setup the Torque Tester:

** Mode:- Peak or TRACK

** Select an appropriate Unit (ft-lb, Nm, etc.)

· Setup the Motorized Control Box:

** Press F1 key to select Dial Mode.

The LCD display reads:

Press RUN key to start Dial Mode:

The LCD Display reads:

Use the cursor keys Up, Down, Left, Right to enter

Target Value, Number of Cycles and Direction.

Typically, the Target Value in Dial Mode should be

about -5% to -10% of the required torque.

Example :

For Dial wrench check at 55 ft-lb, set Target Value at 50 ft-lb.

Press RUN or Enter key to accept all Parameters.

NOTE :

The default Setup upon Power up is :

* Target : 7% of Transducer.

* Cycle: 00001

* Dir: CW

The MCB does NOT accept any Target value that exceeds

Max Transducer Range.

*** MODE (Dial) ***

Press Run to Start

*** DIAL MODE ***

Target Cycle Dir

50.00 ft-lb 00005 CW

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 101 102

Keine Kommentare

Snap-on Motorized Loader Bedienungsanleitung Seite 88